C8 Corvette Stingray Full Coverage Side Intake Mesh Grille Guards

 

Product Side Intake Mesh Grille Insert

Fitment For Corvette C8 2020-Up 

Color Black

Material: CNC laser cut from aluminum and then powder coated in a black finish to blend in front of your inlets. We’re the only ones out there who took the time to create this bolt-in solution with a custom machined punch pattern to match the OEM style.

Features：

1. An OEM like side inlet guards solution! Protect your radiator (Z51 owners) and intake inlets from unwanted road debris and rocks! Includes drivers & passengers side.

2. Easy installation with a bolt-in OEM point to create a sturdy and OEM-like grill guard that should have been there from the factory. These have been track and road-tested to withstand whatever you throw at them, or what gets thrown at you.

OEM style design and look：

It uses an OEM bolt-in location – No cheesy zip ties.

CNC laser cut Aluminum (Not plastic so that it won’t crack.)

Track tested and approved. Handles 180+ MPH. Does not impede airflow.

Durable powder coat finish.

Installation steps:

1. First you want to squeeze the clips in front of the hole and behind the hole for a tight fit then attach them to the main bracket and L bracket push in from the fat end on the brackets towards the smaller end.

2. Use a T-15 bit ratchet and extension to remove the T-15 screw from inside the lower portion of the vent.

3. Insert the T-15 screw into the back end of the main bracket, Clean off the inside of the vents with rubbing alcohol and a rag, Then install the main bracket back where the T-15 screw goes.

4. Add the tape to the L bracket and cut off the excess tape that hangs off the L bracket. You can go ahead and install the L bracket right in the area before the inner part of the vent curves upward and hold firmly for 30 to 40 seconds.

5. Add the tape to the tabs on the grill, the upper tab gets tape on the inside and the lower tab gets tape on the outside Please slightly bend the lower tab outward a little bit to ensure it attaches properly to the side wall when ready.

6. Install the grill with the upper tab behind the inner panel try not to stick it on till you adjust the grill properly and make sure the grill is in front of the brackets.

7. Set the two screws through the grill and into the brackets do not tighten all the way yet just kind of snug then apply pressure on the top tab for 30 to 40 seconds. Then apply pressure to the lower slightly bent tab for 30 to 40 seconds then finally tighten your screws onto the grills and brackets with either a 3mm hex key or you can also use the T-15 ratchet bit to tighten them.