Sale!
Carbon Fiber Universal Chevy Bowtie Emblem Wrap Sheet Kit Overlay
$18.00
-
DIY Universal Emblem Wrap Kit
- DIY emblem wrap kit included only, emblem NOT incuded
- NOT a pre-cut kit. Includes emblem wrap sheets
Compatibility
- Will work on a majority of Chevy vehicles. The portion of the emblem being wrapped must be within 9-3/8″ wide and 4″ tall.
- This kit will NOT fit Chevy 2500 models. Please see our other listings for our large emblem wrap kit
Includes
- (2) 9-3/8″ by 4″ vinyl sheets (Not precut)
- One kit includes (2) sheets to cover (2) emblems
Overview
- Allows you to obtain a custom appearance to your Chevy emblem without permanently changing it.
- Easier to install than a pre-cut decal. Allows more room for error. Apply the vinyl sheet and trim away the excess.
- Our emblem wrap material has been tested to specifically work on the sharp contours of emblems
- Our emblem wrap material is rated for 3-7 years of outdoor use. (depending on environmental conditions)
- Protects emblems from scratches and normal wear and tear
Satisfaction Guarantee
All of our products come with a satisfaction guarantee. Our products are designed and manufactured in-house, in the USA. We take pride in our customer support, so please contact us if you have any issues with our products before leaving a review. We are not satisfied until you are.
Installation Instructions
- Thoroughly clean emblem surface with soapy water. Followed up by rubbing alcohol with a lint free cloth
- Carefully remove the vinyl from white backing paper.
- Hold the vinyl up to the emblem without making contact with it. Ensure that you have the sheet centered with enough excess on all sides of the emblem
- Once satisfied with alignment, start applying the emblem from the center to the outside. It is important to take your time with this part, lifting and reapplying the vinyl if there are any large air bubbles. (A credit card can be used as a squeegee when applying the vinyl).
- For the Camaro grill emblems that have a crease in the middle of the bowtie, it may be necessary to pull and stretch the vinyl out from the center of the emblem. This will help avoid wrinkle marks.
- Once the vinyl is applied, work the vinyl into all corners of the emblem. This should give you a clean outline of the bowtie emblem.
- Carefully follow the outline of the emblem with a razor blade. (we recommend a single edge blade as shown in the photo below) Remove excess vinyl from the outside of the emblem.
- If bubbles exist and do not dissipate within a couple of days, they can be popped with a needle/pin
| Color |
|---|
Be the first to review “Carbon Fiber Universal Chevy Bowtie Emblem Wrap Sheet Kit Overlay”
You must be logged in to post a review.
Related products
Sale!
$52.99 – $54.99
-
Sale!
$40.00 – $69.99
-
Sale!
Out of stock
$31.99
-
$44.99 – $48.99
-
Reviews
There are no reviews yet.